1998 Honda Accord DX Cabin Air Filter Removal & Installation

download 1. Remove the glove box. See GLOVE BOX . Remove the bolt, screws and the glove box frame. See Fig. 1. 3. Remove the filter from the housing and replace it. See Fig. 3 . 4. Install the filter in the reverse order of removal. Ensure arrow marks on edge of filter face in …

Continue reading ‘1998 Honda Accord DX Cabin Air Filter Removal & Installation’ »

1999 Honda Accord DX Timing & Balancer Shaft Belts Removal & Installation

download TIMING & BALANCER SHAFT BELTS Removal 1. Disconnect negative battery cable, then positive battery cable. Rotate crankshaft counterclockwise until cylinder No. 1 is at TDC of compression stroke. While rotating crankshaft, check water pump for signs of seal leakage. Raise and support vehicle. Remove front tires. Remove engine lower splash shield. 2. Remove accessory …

Continue reading ‘1999 Honda Accord DX Timing & Balancer Shaft Belts Removal & Installation’ »

1998–2002 Honda Accord DX MIL Comes On With DTC P0133

download SYMPTOM The MIL comes on with DTC P0133 (primary heated oxygen sensor slow response). PROBABLE CAUSE Some brands of fuel and/or fuel additive packages may create deposits at the fuel injector tips. This build-up may cause slight air/fuel deviations between each cylinder. Build-up of these deposits, when coupled with very specific driving conditions, may …

Continue reading ‘1998–2002 Honda Accord DX MIL Comes On With DTC P0133’ »

2008 Honda Accord Engine Block Heater V6 Installation Instructions

download INSTALLATION NOTE: • Always use Honda All Season Antifreeze/Coolant Type 2. Using a non-Honda coolant can result in corrosion, causing the cooling system to malfunction or fail. • To avoid burning out the element, do not operate the engine block heater before it is installed in the vehicle and before you add coolant. Customer …

Continue reading ‘2008 Honda Accord Engine Block Heater V6 Installation Instructions’ »

2000 Honda Accord MIL Comes On With DTCs P0171 and/or P0172

download SYMPTOM The MIL (Malfunction Indicator Lamp) comes on with DTCs P0171 (Fuel System Too Lean) and/or P0172 (Fuel System Too Rich) stored in the ECM/PCM. PROBABLE CAUSE Moisture in the fuel pressure regulator. CORRECTIVE ACTION Replace the fuel pressure regulator, and reroute the fuel pressure regulator vacuum line. 1. Locate and identify the three …

Continue reading ‘2000 Honda Accord MIL Comes On With DTCs P0171 and/or P0172’ »