2014 toyota highlander cross bar installation instructions Direct Download speed 7287 Kb/s

  2014 toyota highlander cross bar installation instructions Full Version speed 5567 Kb/s


2009 Toyota Venza Roof Rails & Cross Bars Installation

download 1. Vehicle Preparation. (a) Using tape measure, measure rearward from front window lace 425mm ± 25mm (16¾” ± 1”) and mark the factory ditch mold for cutting. (Fig. 1-1a) (b) Carefully lift ditch molding, starting at the rear to just beyond the cut line. Do not remove molding totally from front ditch & clip. …

Continue reading ‘2009 Toyota Venza Roof Rails & Cross Bars Installation’ »

2008 Toyota 4Runner Roof Rack Cross Bar Installation

download To prevent paint damage during transportation, the roof rack cross bars are kept inside the vehicle so that the Rapgardt protective film can remain in place on the roof panel. Install the roof rack cross bars to the roof rack rails according to the following procedure during Pre-Delivery Service (PDS). Installation Procedure (Continued) 2. …

Continue reading ‘2008 Toyota 4Runner Roof Rack Cross Bar Installation’ »

1995-2002 TOYOTA TACOMA 4 X 4 AND PRERUNNER 3″ SUSPENSION LIFT KIT INSTALLATION INSTRUCTIONS

REVTEK INDUSTRIES Tacoma 4WD & PreRunner Installation Instructions FRONT OF VEHICLE 1. Park vehicle on level concrete surface. 2. Center and lock the steering wheel. 3. Block the rear wheels of the vehicle to prevent vehicle from moving in either direction. 4. Jack up the vehicle from the lift point in Figure “A.” 5. Support …

Continue reading ‘1995-2002 TOYOTA TACOMA 4 X 4 AND PRERUNNER 3″ SUSPENSION LIFT KIT INSTALLATION INSTRUCTIONS’ »

Toyota Urethane Adhesive Sealant For Fixed Glass Installation

This bulletin is a supplement to the previous 1986 Windshield Installation Procedure TSB, body number 032, Volume VIII, dated 08–22–86. In order to comply with FMVSS 212 – Windshield Retention and FMVSS 216 – Roof Crush Resistance, the factory uses a Urethane adhesive sealant with bonded strength of not less than 40 kilograms per square …

Continue reading ‘Toyota Urethane Adhesive Sealant For Fixed Glass Installation’ »

Toyota TUNDRA (UCK30, 40 and VCK30, 40) Limited Slip Differential Installation

Toyota TUNDRA Limited Slip Differential Installation For parts, supplies, and tools required, refer to the Toyota Repair Manual. With a few exceptions, installation of the limited slip differential is the same as the remove and replace procedure described in the manual. The exceptions are noted in these instructions. Section II. Vehicle Disassembly Procedure Please follow …

Continue reading ‘Toyota TUNDRA (UCK30, 40 and VCK30, 40) Limited Slip Differential Installation’ »