2002 Honda Accord DX Timing Belt Installation

download 1. Clean tensioner pulleys. Ensure cylinder No. 1 is at TDC by aligning dimple on timing belt drive pulley with pointer on oil pump housing. See Fig. 4. Ensure camshaft pulley TDC marks are aligned. See Fig. 5. 2. Install camshaft timing belt counterclockwise in sequence shown. See Fig. 6. Loosen and retighten tensioner …

Continue reading ‘2002 Honda Accord DX Timing Belt Installation’ »

1998 Honda Accord LX Timing Belt Replacement

download Removal and Installation REMOVAL Special Tools Required – Holder Handle 07JAB-001020A – Holder Attachment, 50 mm, Offset 07MAB-PY3010A – Socket, 19 mm 07JAA-001020A or a commercially available 19 mm socket 1. Make sure you have the anti-theft code for the radio, then write down the frequencies for the radio’s preset buttons. 2. Disconnect the …

Continue reading ‘1998 Honda Accord LX Timing Belt Replacement’ »

1995 Honda Accord Sedan Timing Belt Replacement

download NOTE: Mark the direction of rotation on the belt before removing. Do not use the upper covers and lower cover for storing removed items. Clean the upper covers and lower cover before installing. Replace the camshaft seals and crankshaft seals if there is oil leakage. Refer to crankshaft pulley before installing timing belt. Replace …

Continue reading ‘1995 Honda Accord Sedan Timing Belt Replacement’ »

2000 Honda Accord EX Coupe Timing Belt and Balancer Belt Removal

download Special Tools Required Holder Handle 07JAB-001020A Holder Attachment, 50 mm, Offset 07MAB-PY3010A Socket, 19 mm 07JAA-001020A or a commercially available 19 mm socket 1. Make sure you have the anti-theft code for the radio, then write down the frequencies for the radio’s preset buttons. 2. Disconnect the battery negative terminal first, then the positive …

Continue reading ‘2000 Honda Accord EX Coupe Timing Belt and Balancer Belt Removal’ »

1990 Honda Accord DX Timing & Balance Shaft Belts Removal & Installation

download Removal 1. Disconnect negative battery cable. Position crankshaft with cylinder No. 1 at TDC of compression stroke. See Fig. 1 , Fig. 2 or Fig. 3 . Disconnect battery negative cable. Remove splash shield. Remove cruise control actuator, leaving cable connected. Remove power steering pump, leaving hoses connected. 2. Disconnect alternator wiring. Remove wiring …

Continue reading ‘1990 Honda Accord DX Timing & Balance Shaft Belts Removal & Installation’ »