how to remove the 3rd row seat in a 2014 explorer Direct Download speed 7287 Kb/s

  how to remove the 3rd row seat in a 2014 explorer Full Version speed 5567 Kb/s


2013–2014 Ford Taurus, 2012–2014 Edge, Explorer, 2013–2014 Lincoln–2.0L GTDI Engine– Driveability Concerns – DTCS P0128/ P010 Or P0236

Some 2012 – 2014 Edge, Explorer, 2013 – 2014 MKT and Taurus vehicles equipped with a 2.0L Gasoline Turbocharged Direct Injection (GTDI) may exhibit difficult to start, runs rough, crank-no start, lack of power, loss of idle RPM or hesitation concerns with diagnostic trouble codes (DTCS) P0106, P0236, or a repeat P0128. These conditions may …

Continue reading ‘2013–2014 Ford Taurus, 2012–2014 Edge, Explorer, 2013–2014 Lincoln–2.0L GTDI Engine– Driveability Concerns – DTCS P0128/ P010 Or P0236’ »

2005 Ford Explorer Rear Seat – Third Row Removal and Installation

download 1. Release the 2 levers located at the lower outboard edges of the seat cushion, lift the cushion up and pull the cushion out. 2. Remove the 2 third row backrest-to-floor nuts. To install, tighten to 40 Nm (30 lb-ft). 3. Remove the 2 third row backrest-to-floor outer bolts. To install, tighten to 10 …

Continue reading ‘2005 Ford Explorer Rear Seat – Third Row Removal and Installation’ »

2004 Ford Explorer Sport Trac How To Remove and Install Parking Brake and Actuation

download Removal 1. NOTE: Make sure the parking brake control is fully released. Relieve the tension on the parking brake system. 1 Pull the front parking brake cable and conduit. 2 Insert a 4 mm (5/32-inch) drill bit or equivalent retainer. 2. Raise and support the vehicle. For additional information, refer to Section 100-02. 3. …

Continue reading ‘2004 Ford Explorer Sport Trac How To Remove and Install Parking Brake and Actuation’ »

1994 Ford Explorer How to Remove Front Wheel Bearings

download Dana 35-IFS & Automatic Locking Hubs 1. Raise and support vehicle. Remove front wheel assemblies. Remove retaining washers from wheel lug nut studs. See Fig. 1 . 2. Remove automatic locking hub assemblies. Remove snap ring and axle shaft spacer. Carefully pull plastic cam assembly from bearing adjusting nut. Remove 2 plastic thrust washers …

Continue reading ‘1994 Ford Explorer How to Remove Front Wheel Bearings’ »

2014 Ford Escape – Engine Stays Running After The Ignition Is Shut Off

Some 2014 Escape vehicles built on or before 7/15/13 may exhibit a concern with the engine still running after the ignition is shut off. This may be due to a solder short between pins 18 and 19 in the BCM (Body Control Module) for connector C2280F. If a vehicle comes in for this concern, access …

Continue reading ‘2014 Ford Escape – Engine Stays Running After The Ignition Is Shut Off’ »