2004–2006 Toyota Sequoia Rear Axle Bearing Noise

download Introduction Some 2004 – 2006 model year Sequoia vehicles may display one of the following conditions from corrosion inside of the rear axle assembly caused by water intrusion. S An abnormal noise described as a “rumble,” “roar,” or “whir” that seems to be coming from the front of the vehicle that increases in sound …

Continue reading ‘2004–2006 Toyota Sequoia Rear Axle Bearing Noise’ »

2004 Ford F150 Rear Axle Differential Cover, Axle Shaft, Oil Seal, and Rear Wheel Bearing Removal And Installation

download 1. With the vehicle in NEUTRAL, position on a hoist. For additional information, refer to Section 100-00. 2. Remove the rear wheel and tire assembly. For additional information, refer to Section 204-00. 3. Remove the parts in the order indicated in the following illustration and table. 4. To install, reverse the removal procedure. 5. …

Continue reading ‘2004 Ford F150 Rear Axle Differential Cover, Axle Shaft, Oil Seal, and Rear Wheel Bearing Removal And Installation’ »

2002-2005 Ford Explorer Noise From Rear Wheel Hub Bearings

download ISSUE Some 2002-2005 Explorer 4dr/Mountaineer and 2003-2005 Aviator vehicles may exhibit a noise from the rear wheel hub bearings. Previous service procedures required service replacement of the wheel hub bearing assembly, base part (1109). This new service procedure allows replacement at a lower service level of the wheel bearing, base part (1215) to repair …

Continue reading ‘2002-2005 Ford Explorer Noise From Rear Wheel Hub Bearings’ »

2004 Ford Freestar noise from front wheel hub bearing

Issue some freestar/monterey vehicles may exhibit a new vehicle limited high pitched whistling/squealing noise from the front exterior while driving, accelerating and/or cruising. Operation description time the noise usually starts after 5-10 minutes of driving and goes away with steering wheel input. Action 041613b replace both front wheel 1.6 hrs. To service, replace the front …

Continue reading ‘2004 Ford Freestar noise from front wheel hub bearing’ »

2001 Subaru Legacy Wheel Bearing Disassemble

download Remove knuckle. Refer to Steering and Suspension. Using ST1 and ST2, remove hub from rear housing. Remove back plate from rear housing. Using a standard screwdriver, remove outer and inner oil seals. CAUTION: Use new oil seals. 5. Using flat bladed screwdriver, remove snap ring. 6. Using ST1 and ST2, remove bearing by pressing …

Continue reading ‘2001 Subaru Legacy Wheel Bearing Disassemble’ »