2009 Toyota Venza Door Panel Trim Delamination

download Introduction Some 2009 model year Venza vehicles may experience a condition where the front or rear door panel trim delaminates. Improved door panels have been developed to correct this condition. Repair Procedure Front Door 1. Disconnect the cable from the negative (-) battery terminal. 2. Using a molding remover, disengage the 3 claws and …

Continue reading ‘2009 Toyota Venza Door Panel Trim Delamination’ »

2007 Honda Civic Door Panel Removal/Installation

download Special Tools Required KTC trim tool set SOJATP2014* Trim pad remover, Snap-on A 177A or equivalent, commercially available *Available through the Honda Tool and Equipment Program; call 888-424-6857 2-door NOTE:  Use the appropriate tool from the KTC trim tool set to avoid damage when removing components. Take care not to scratch the door …

Continue reading ‘2007 Honda Civic Door Panel Removal/Installation’ »

1997 Hyundai Sonata Timing Belt Replacement

download Removal 1. Remove all drive belts. Remove crankshaft pulley and water pump pulley. Remove upper and lower timing belt covers, noting bolt lengths and locations. 2. Turn crankshaft clockwise and align timing marks so No. 1 cylinder is at TDC. Timing marks on camshaft sprockets should be aligned at upper surface of cylinder head. …

Continue reading ‘1997 Hyundai Sonata Timing Belt Replacement’ »

2004 Hyundai Sonata Timing & Counterbalance Shaft Belts Removal & Installation

download CAUTION: This application is an interference engine. Do not rotate camshaft or crankshaft when timing belt is removed, or engine damage may occur. TIMING & COUNTERBALANCE SHAFT BELTS Removal CAUTION: DO NOT rotate engine counterclockwise (as viewed from timing belt end of engine). If reusing timing belt, place reference mark on timing belt to …

Continue reading ‘2004 Hyundai Sonata Timing & Counterbalance Shaft Belts Removal & Installation’ »

2005–2009 Toyota Tacoma Instrument Panel Rattle Below Glove Box

download 2005 – 2009 model year Tacoma vehicles may exhibit an instrument panel rattle or tick noise below the glove box area. The faint noise is most evident when accelerating slowly between the 1000 – 1600 RPM range. The rattle has been found to be coming from a wire harness cover coming into contact with …

Continue reading ‘2005–2009 Toyota Tacoma Instrument Panel Rattle Below Glove Box’ »