toyota highlander 2014 cross bars installation Direct Download speed 7287 Kb/s

  toyota highlander 2014 cross bars installation Full Version speed 5567 Kb/s


2008 Toyota 4Runner Roof Rack Cross Bar Installation

download To prevent paint damage during transportation, the roof rack cross bars are kept inside the vehicle so that the Rapgardt protective film can remain in place on the roof panel. Install the roof rack cross bars to the roof rack rails according to the following procedure during Pre-Delivery Service (PDS). Installation Procedure (Continued) 2. …

Continue reading ‘2008 Toyota 4Runner Roof Rack Cross Bar Installation’ »

2009 Toyota Venza Roof Rails & Cross Bars Installation

download 1. Vehicle Preparation. (a) Using tape measure, measure rearward from front window lace 425mm ± 25mm (16¾” ± 1”) and mark the factory ditch mold for cutting. (Fig. 1-1a) (b) Carefully lift ditch molding, starting at the rear to just beyond the cut line. Do not remove molding totally from front ditch & clip. …

Continue reading ‘2009 Toyota Venza Roof Rails & Cross Bars Installation’ »

2001 Toyota Highlander Hood Protector Installation

download A. Pre-Installation Preparation. 1. Inspect and verify the kit contents. 2. Open the hood. 3. Make sure front edge of hood, where the deflector is to be installed, is clean and free from dirt and/or debris. Use 3MTM Prep Solvent-70. i. When cleaning with 3MTM Prep Solvent-70 follow the manufacturer’s directions. Do not allow …

Continue reading ‘2001 Toyota Highlander Hood Protector Installation’ »

2004 Toyota Highlander Receiver Hitch Installation

download Section II − Installation Procedure A. Protect Exhaust Pipe. 1. Cover exhaust pipe with clean shop towel. (Fig. A−1) STOP NOTE: Muffler/Tail pipe may be sharp and/or hot. B. Remove Tie−Downs & Hole Plugs. 1. Remove and discard tie−downs, four (4) bolts and seven (7) domed rubber plugs from vehicle. (Fig. B−1) 2. Remove …

Continue reading ‘2004 Toyota Highlander Receiver Hitch Installation’ »

2000 Toyota Sienna LE Combination Switch Removal & Installation

download Disconnect negative battery cable. Remove steering column covers (it may be necessary to first remove lower finish panel from instrument panel). Disconnect headlight/dimmer and turn signal switch connector. Remove screws and headlight/dimmer and turn signal switch. See Fig. 9 . To install, reverse removal procedure. 1. Ensure front wheels are in straight-ahead position. Turn …

Continue reading ‘2000 Toyota Sienna LE Combination Switch Removal & Installation’ »