2003 Toyota Corolla & Matrix Rear Drum Brake Overhaul

download Hint: overhaul the rh side by the same procedures as lh side. 1. Remove rear wheel 2. Drain brake fluid notice: wash the brake fluid off immediately if it comes into contact with any painted surface. Contract 3. (a) hint: if the brake drum cannot be removed easily, do the following steps. (b) remove …

Continue reading ‘2003 Toyota Corolla & Matrix Rear Drum Brake Overhaul’ »

2003 Toyota Corolla & Matrix Rear Axle Hub & Bearing Assy Lh Replacement

download 2. Separate rear disc brake caliper assy lh (disc rear brake type) remove the 2 bolts, separate the rear disc brake caliper assy lh. (a) remove rear disc (disc rear brake type) remove rear brake drum sub–assy (drum rear brake type) disconnect skid control sensor wire (w/ abs) 6. (a) remove rear axle hub …

Continue reading ‘2003 Toyota Corolla & Matrix Rear Axle Hub & Bearing Assy Lh Replacement’ »

2010 Toyota Prius Rear Brake Squeak

download Some 2010 Toyota Prius vehicles may experience rear brake squeak when backing up or moving forward during the first few brake applications when the brakes are cold. An updated rear brake shim kit is available to reduce the likelihood of this condition occurring. Repair Procedure 1. Test drive the vehicle to confirm the squeak …

Continue reading ‘2010 Toyota Prius Rear Brake Squeak’ »

2003–2008 Toyota Corolla Front Brake Rattle Noise

download Introduction Some customers may experience a front brake rattle type noise when the car is traveling over bumps. Updated front disc brake cylinder (caliper) mountings and disc brake pad support plates are available to eliminate this condition. Repair Procedure 1. Conduct a road test to verify the noise condition — front brake rattle noise …

Continue reading ‘2003–2008 Toyota Corolla Front Brake Rattle Noise’ »

2003 Toyota Corolla & Matrix Valve Clearance (1Zz–Fe) Adjustment

download 1. (a) remove cylinder head cover no.2 remove the 2 nuts, 2 clips and cylinder head cover. 2. (a) disconnect engine wire remove the 5 clamps from the 5 clamp brackets. (b) disconnect the 4 ignition coil connectors. (c) remove the bolt and nut installing the engine wire. 3. (a) remove ignition coil assy …

Continue reading ‘2003 Toyota Corolla & Matrix Valve Clearance (1Zz–Fe) Adjustment’ »