2002 Ford Taurus Water In The Blower Case – Blower Motor And/Or Resistor Failure

FORD: 2001-2004 Taurus MERCURY: 2001-2004 Sable This article supersedes TSB 03-15-06 to update the vehicle model years and build date information. ISSUE Some vehicles built between 5/1/2001 and 12/15/2003 may exhibit water in the blower case or on the passenger side floor, an inoperative climate control blower motor, a motor that operates on high speed …

Continue reading ‘2002 Ford Taurus Water In The Blower Case – Blower Motor And/Or Resistor Failure’ »

1998 Dodge Dakota Water Pump Removal & Installation

download CAUTION NEVER open, service or drain the radiator or cooling system when hot; serious burns can occur from the steam and hot coolant. Avoid physical contact with the coolant. Wear protective clothing and eye protection. Always drain coolant into a sealable container. Clean up spills as soon as possible. Coolant can be reused as …

Continue reading ‘1998 Dodge Dakota Water Pump Removal & Installation’ »

2003 Ford Windstar How to Remove and Install Water Pump

download Removal 1. Disconnect the battery ground cable. For additional information, refer to battery, mounting and cables . 2. Drain the cooling system. For additional information, refer to cooling system draining, filling and bleeding . 3. Remove the accessory drive belt. For additional information, refer to accessory drive . 4. Raise and support the vehicle. …

Continue reading ‘2003 Ford Windstar How to Remove and Install Water Pump’ »

2004 Mazda 6 i How to Remove and Install Water Pump Drive Belt

download 1. Verify that the water pump drive belt auto tensioner indicator mark does not exceeds the limit.  if it exceeds the limit, replace the water pump drive belt. (see water pump drive belt .) fig. 21: water pump drive belt auto tensioner limit indicator mark – malfunction/worn belt water pump drive belt 1. …

Continue reading ‘2004 Mazda 6 i How to Remove and Install Water Pump Drive Belt’ »

2002 Mazda Protege LX Timing Belt Removal

download 1. Disconnect negative battery cable. Remove Crankshaft Position (CKP) and Camshaft Position (CMP) sensors from front of engine (if equipped). See Fig. 1 . Remove spark plugs. 2. Remove accessory drive belts. Leaving hoses attached, remove power steering pump and position aside. Remove the water pump pulley. See Fig. 2 . Rotate crankshaft so …

Continue reading ‘2002 Mazda Protege LX Timing Belt Removal’ »